Page 1 of 1
Walther grip question
Posted: Wed Nov 19, 2014 7:09 pm
by Leon
Does a grip for a LP300 fit a GSP?
I've just bought a new grip on egun, ostensibly for GSP, but the seller has informed me that some people had emailed him telling him that the grip was for an LP300.
He did say that it has been tried on a GSP ( not screwed ) nut I don't want to make an expensive mistake....
Picture of grip here -
http://www.egun.de/market/item.php?id=5174454
Anybody?
Re: Walther grip question
Posted: Wed Nov 19, 2014 10:52 pm
by David M
Re: Walther grip question
Posted: Thu Nov 20, 2014 2:36 am
by ghostrip
mount hole for the two grips are completely different. also even if you successfully screw the lp300 on to a gsp i am pretty sure total dimensions will not comply with issf rules (most of the gsp with their original grips i have seen are a very tight fit in the issf rule box). perhaps you should contact your seller and mutually cancel your winning bid.
Re: Walther grip question
Posted: Thu Nov 20, 2014 2:51 am
by David Levene
I know that pictures can be deceptive with nothing to reference them against but I would be suspicious of this being a GSP grip.
I could easily be wrong but the rear overhang appears to be greater than the 30mm allowed.
Re: Walther grip question
Posted: Thu Nov 20, 2014 3:49 am
by JamesH
I'm 100% sure that's not for a GSP, more likely an LP300.
Re: Walther grip question
Posted: Thu Nov 20, 2014 5:28 pm
by Leon
Thanks guys - the seller and I have mutually agreed not to proceed with the sale...
Re: Walther grip question
Posted: Fri Nov 21, 2014 6:32 am
by Crete
GSP Expert on the left and LP300 on the right.
