Page 1 of 1
Anschutz 64 Match trigger work
Posted: Sun Apr 22, 2012 7:18 pm
by jerryg22
Hi. I just picked up a used 64 Match in very nice condition. The trigger measures 4.5# and I cannot find any instructions for adjusting it. I have a feeling it may need to go to a good gunsmith to have it reworked to about 1#. I'm including a picture of it. I'm thinking that it will need a lighter spring plus some minor tweaking. A good Anschutz Gunsmith recommendation or any suggestions are welcomed. Thanks.
adjusting as follows...
Posted: Mon Apr 23, 2012 1:13 pm
by Albert T
The vertical screw most forward of the trigger sets the triggerpressure. clockwise = heavier, ccwise = less
The screw with nut diagonal just in front of trigger determines the lettoff point. clockwise = larger creep, ccwise is less creep.
The diagonal screw with nut behind the trigger determines the trigger slack before reaching lettoff point (length of first stage) clockwise = less slack, ccwise is longer slack
the nuts are used to secure the little screws.
Albert (The Netherlands)
Posted: Tue Apr 24, 2012 9:30 pm
by jerryg22
Well I finally figured it out and have a phenominal safe trigger. I replace the spring under the front toggle and now it is under 8 ounces with a crisp let off. My tigger guage is not digital and only goes as low as 8 ounces so I don't know the exact weight.