Page 1 of 1
SCATT Question
Posted: Fri May 20, 2011 11:21 am
by cmj
Anybody know what it means when the top center light is gowing red on the target frame. have never seen that in about 3 years . The big light in the middle.
Thanks
Posted: Fri May 20, 2011 3:32 pm
by caa028
Rapid fire mode (it will stay red for 7 seconds then go off and the green one will come up for 3 seconds, and the whole cycle repeats). Enabled by the event type...
Posted: Fri May 20, 2011 4:28 pm
by cmj
Scatt was set for 10m air rifle and red light stayed steady, did not change to green.
Scatt question more info
Posted: Fri May 20, 2011 7:51 pm
by cmj
It seems like the red light comes on when the "adjust optical sensor" is clicked on and goes out when it is closed. Just started doing it couple days ago.
Posted: Sun May 22, 2011 3:54 pm
by Guest
This is for the initial calibration shot. Fire one shot; if somewhere in the circle, click to close; and the light goes off.
Posted: Sun May 22, 2011 6:33 pm
by cmj
Had pretty much decided that was the case, seems like is incoporated into the last 2 software versions. reinstalled an earlier version and did not get the red light anymore, so went back to te latest and the red light came back. First couple times did not expect it and wondered if something was broke etc.