FWB LP 100 Seal replacement
Posted: Wed Jan 05, 2011 8:23 pm
I have a FWB LP 100 I would like to replace the seals. I have a seal kit
and and some instructions from a german site on how to go about it.
Everything is straightforward until I tried to remove the two angled allan screws that hold the piston cylinder housing to the valve trigger assembly.
They seem to be locked solid, the allen key is the original Feinwerkbau one and I am assuming that the allen screws are hardened and of good quality, however I don't wish to proceed for fear of stripping out the allan screw heads. Any advise would be welcome.
Cheers.
Paul.
and and some instructions from a german site on how to go about it.
Everything is straightforward until I tried to remove the two angled allan screws that hold the piston cylinder housing to the valve trigger assembly.
They seem to be locked solid, the allen key is the original Feinwerkbau one and I am assuming that the allen screws are hardened and of good quality, however I don't wish to proceed for fear of stripping out the allan screw heads. Any advise would be welcome.
Cheers.
Paul.