Page 1 of 1
Where to Train in San Jose, CA? (10m Air Rifle, ISSF)
Posted: Sat May 22, 2010 8:19 pm
by 10mair
I've been searching for 10m air rifle (ISSF) ranges near San Jose, CA, but I could not find any. If anyone knows any shooting range that I can practice at, plz let me know the add. and contact info.
Thanks.
Posted: Sat May 22, 2010 10:27 pm
by GaryN
I know there is a range in San Mateo, at Coyote Point.
I've shot there before, but that was a few years ago.
There are a couple closer to you that I have heard about but never been to:
Sunnyvale Rod and Gun Club
srgc.simplenet.com
Los Altos Rod and Gun Club
Posted: Sun May 23, 2010 11:40 am
by john bickar
Santa Clara Valley Rifle Club
BTW, the website for Sunnyvale Rod & Gun is
http://www.sunnyvalegunclub.com , but they don't do 10M ISSF Air Rifle.
Posted: Sun May 23, 2010 5:42 pm
by 10mair
Thanks for your replies.
Unfortunately, all of the above ranges do not have an ISSF 10 meter air rifle/pistol range. I need to find a range which has built and used for only "ISSF" 10 meter air rifle/pistol. The range must have the 1.4 meter target height, 10 meter distance and target mover(or electronic target).
If anyone knows, plz let me know.
Posted: Mon May 24, 2010 9:51 am
by WRC
Since most none of us in the USA shoot to complete "ISSF" rules, you are going to do a lot of looking and traveling to get a range to those specs. Likely Fort Benning, maybe the CMP ranges at Camp Perry Ohio & Anniston Ala, and the Olympic Training Center in Colo Springs Colorado are the only real ones.
Perhaps a really interested club would allow you to set up your own target system for demo purposes and your use.
Posted: Mon May 24, 2010 12:08 pm
by GaryN
Did you check out Coyote Point?
They do shoot 10m AP and AR
They use a manual target carrier, so you are shooing on paper, not electronic scoring.
10 air rifle
Posted: Wed May 26, 2010 5:45 pm
by guester
Try the Palo Alto Gun club.
They have held the state air rifle championships there.
It is a nice little range for competitive shooters.
Lucho
Posted: Sun May 30, 2010 8:06 pm
by compscotty