High Standard Military rear sight removal

A place to discuss non-discipline specific items, such as mental training, ammo needs, and issues regarding ISSF, USAS, and NRA

If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true

Moderators: pilkguns, m1963, David Levene, Spencer, Richard H

Post Reply
CPT-DAN
Posts: 1
Joined: Tue Jul 01, 2008 9:17 pm
Location: Micigan

High Standard Military rear sight removal

Post by CPT-DAN »

Does any one know how to remove the rear sight bridge from a HS Military series frame. It appears to be held on by a two piece rivet and a roll pins. thanks, Dan
Top
User avatar
jackh
Posts: 802
Joined: Sat Sep 25, 2004 8:51 pm
Location: Oregon USA

Post by jackh »

Drive the center rear roll pin into the sear area. You should remove the sear first. Through the little hole in one large pin, drive out its' other half with a punch. The pin halves can be very tight. Then drive out the remaining half from the other side. The two side roll pins need to be driven in JUST enough to free their bridge sight legs. If you drive them too far they will hit the far side.
Top
Post Reply

Return to “Shooters Lounge”