target stand
Moderators: pilkguns, m1963, David Levene, Spencer, Richard H
-
Guest
target stand
I have a question about what to use behind a 10M air rifle stand to stop pellets.
CMP WEBSITE
Go to this link for two types of stands:
http://www.odcmp.com/Coaching/target_stand_plans.htm
I prefer the Lujan type of stand as I can have my shooters setup a full set of 3x20 targets and not have to change the backstop position after each position.
If you build these in sets of 4 they will run about $50-60 apiece to construct
If it is for personal use check out the Targetworx traps ... the target rolls are more expensive than the AR 5/10's though. (a google search will find them)
http://www.odcmp.com/Coaching/target_stand_plans.htm
I prefer the Lujan type of stand as I can have my shooters setup a full set of 3x20 targets and not have to change the backstop position after each position.
If you build these in sets of 4 they will run about $50-60 apiece to construct
If it is for personal use check out the Targetworx traps ... the target rolls are more expensive than the AR 5/10's though. (a google search will find them)
taret back stop material
Ours are built for 3P
The back board is 1/2 plywood but we mounted 14 Ga steel sheet to it.
We oil it every now and then to keep the rust down and it helps kep the pellets sliding off of it after they flatten.
The back board is 1/2 plywood but we mounted 14 Ga steel sheet to it.
We oil it every now and then to keep the rust down and it helps kep the pellets sliding off of it after they flatten.