How must be the first charge of the battery ?
For a new pistol : Must I do a full charge to the battery, before use the pistol?
Thank for your comments
Ramón
Battery of EVO 10E
Moderators: pilkguns, m1963, David Levene, Spencer, Richard H
Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
Re: Battery of EVO 10E
With most batteries of various technologies its a good idea to start a new battery with a full charge.
That said if its LiPo its not ideal to store them for long periods fully charged.
Its curious the manual says nothing.
That said if its LiPo its not ideal to store them for long periods fully charged.
Its curious the manual says nothing.
Re: Battery of EVO 10E
The EVO battery is a single cell Li-Po 3.7v 360mah 1.296wH (LP552036).
Typically Li-Po are shipped with a 40% storage charge.
It can be charged with a micro USB charger, depending on output 10- 50 min to 100%.
Typically Li-Po are shipped with a 40% storage charge.
It can be charged with a micro USB charger, depending on output 10- 50 min to 100%.
Re: Battery of EVO 10E
Thanks, since its a LiPo charge to 100% on first use, but just before you plan to use it.
Then try not to drop it to zero at any time, and if its going to be stored aim for 50% if you can.
A USB charger is a dumb charger, I can't see from the photo - is there any battery management electronics in there?
Absolutely don't overcharge, always attend when charging, ideally put it in a metal pan.
Then try not to drop it to zero at any time, and if its going to be stored aim for 50% if you can.
A USB charger is a dumb charger, I can't see from the photo - is there any battery management electronics in there?
Absolutely don't overcharge, always attend when charging, ideally put it in a metal pan.
Re: Battery of EVO 10E
Some Li-Po cells have a small circuit built in for under and over voltage protection.
For simple Li-Po cells usually this voltage protection is built into the attached trigger circuit board and charger circuit.
For simple Li-Po cells usually this voltage protection is built into the attached trigger circuit board and charger circuit.