Pardini Fiocchi P10

[jdurao]

Hi there
I have recently purchased a Pardini-Fiocchi P10 in a poor condition and decided to overhaul it completely as much as possible to its original condition. I have already ordered at local dealer, a complete set of seals. After dismounting almost entirely the gun, I realised that, so far, and due to lack of instructions/manuals, I am not able to separate the trigger/valve control system, apart from the compression cylinder
Perhaps someone out there, more experienced in this could help me to face this specific task.

[DFWdude]

Does this help?

http://www.pilkguns.com/tenp/spparp10.htm

[jdurao]

Tks a lot DFWdude, however despite helpful, it does not mention the solution to dismount the cylinder and keeping it apart from the trigger assembly.

[DFWdude]

It's been three decades since I worked on a P10. Does the compression tube simply not pull away from the trigger group? It's not held in place by any screws that I can remember... only by the pressure of it's o-ring.

BTW, here is a link to the official manual... http://www.pardini.it/manuali/manual%20 ... %20p10.pdf

[10M_Stan]

The Pardini P10 kit shows the same diagram with a bit better resolution: https://www.pardiniguns.com/store/produ ... cts_id=908

If the cylinder seems 'stuck' to the trigger group, perhaps some Kroil might help? If that sounds like Japanese, then disregard.

Good luck!

Stan

[jdurao]

Yes fellows, many thanks for yr kind cooperation. You are correct. I am going to try to detach the cylinder this way, otherwise I suppose I have to keep it in the current place and forget to replace the associated seals including the valve ones...