SKATT PROBLEMS

[philipelhage]

Hello,

This is my first post here.
I started shooting again in the last 6 months and remembered i have an old scatt system at home that i never installed.
I setup everything and downloaded software but i keep getting the error device not found when starting a new practice.

This is an old system. It doesn't use the USB either.

Maybe i have the wrong software.

Any help would be appreciated.

Regards,

Philip

[shaky hands]

Make sure you have the drivers installed. Go to
http://www.scatt.com/downloads/70/downloads/
and download and install both the software and drivers.

[philipelhage]

Thank you,

finally got it to work but now i'm only shooting 10.9's
Trying to calibrate it but with no luck.

Any suggestions?

[deadeyedick]

but now i'm only shooting 10.9's

You are good !

[DanielSwe]

Those damn paper targets does that to me all the time :(

[dsaptarshi]

1. Did you adjusted and calibrated your Optical sensor by pressing F2 ?
2. At what distance you are shooting at your target ? (Distance between Scatt and Optical Sensor) ?

[pbrejsa]

Failed program ... it happens, erase what you have and try to install it again
http://www.scatt.ru/download/50/downloads/
or ask here
http://www.scatt.com/support/

[philipelhage]

Yes i calibrated by pressing f2, but i tried at 3 meters and 5 meters but the same result.
The tracing seems to be really off.

Thank you very much for your time and hope we can solve this issue.

[shaky hands]

Are you sure your SCATT actually supports so short distances? I remember vaguely that old devices required longer ranges. Check the manual, to make sure.

[David Levene]

On the old Scatt serial port units there was a special target frame for 5m.

The normal frame was "questionable" below about 8m.

[Ed Hall]

If you can't find the necessary distance, try a mirror with the target beside you. I did this for a while with my Rika.