My IZH 46M was leaking air when breech lever is compressed. Doug White at MIT correctly guide me to the inner seal problem. I finally took things apart and approached inner seal from rear end. Quite an ordeal, but seal is replaced. Gun no longer leak when breech lever is compressed.
Now got a new problem. The trigger would not fire on first pull. It will fire on second pull. I would pull the trigger until the very end stop, it will not fire. I let go, start again then it will fire.
I don't think it is the second stage or travel stop issue. Both are quite adequately loose.
Sear problem?
IZH 46m trigger no fire on first pull
Moderators: pilkguns, m1963, David Levene, Spencer, Richard H
Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
-
Wynne G Oldman
- Posts: 175
- Joined: Mon Aug 25, 2014 4:36 pm
- Location: Bury, Lancashire, England.
Re: IZH 46m trigger no fire on first pull
I've attached a PDF that may help you with your problem.
- Attachments
-
- IZH-46M%20Stuck%20Trigger%20Sear%20Repair.pdf
- (83.83 KiB) Downloaded 149 times
Morini 162 EI
Anschutz 1913 Supermatch
Anschutz 1913 Supermatch