Hello, new to forum with an FWB P70 FT

thevinoman · Post by **thevinoman** » Fri May 22, 2009 12:46 pm

Hi. Just purchased an FWB P70 FT for Field Target competition here in Washington state and elsewhere. It is blue aluminum, with the laminate forestock and grip. I'm new to the entire range of FWB products, but I do know most of the major dealers.

Am mostly wondering about the types of accessories or replacement parts that will fit on this rifle. Specifically, looking for a forestock replacement (flat block to be used for bench rest), knee risers, and buttplate options.

There seems to be an awful lot of Anschutz parts available, but not all that many FWB. Will some Anschutz parts fit straight drop in, or require mods to the stock, etc?

Sorry for the simple, dumb questions, but, I'm a fast learner. Thanks for any expertise you good folks can provide.

Guest · Post by **Guest** » Fri May 22, 2009 9:24 pm

you might get more answers to these questions on the yellow airgun forum, there are a lot more FT guys over there.

thevinoman · Post by **thevinoman** » Fri May 22, 2009 9:35 pm

Well, although more FT guys, not many with the P70. I've been a member over there for quite a while, and have posted questions, and not had much response. Thanks.

robf · Post by **robf** » Sat May 30, 2009 6:43 pm

if the parts run on a rail, then all rails are the same, so they should fit.