Morini 162EI circuit jumpers HELP!!!!!!!
Posted: Thu Dec 09, 2004 11:31 pm
I need help with this soon...
While replacing the grip on my recently acquired 162EI I accidentally popped out two of the three circuit jumpers at the bottom of the circuit board.
How you may ask. I was in the process of reconnecting the board inside the grip and didn't pay attention to the clearance on both sides of the board. It's tight so there was enough deviation for the internal edge of the grip to catch two of the jumpers and pop them out when I pressed the board in. Enough of that!
Can anyone open their metal cover at the botton of the grip and tell me what pins are jumpered together? If you can, please pay attention and make sure you start with the pin closest to the front of the pistol and to list them as:
1 open, 2 open, 3 jumpered with 4, etc.
Keep in mind that there are only 3 jumpers so no reason to go beyond the last jumpered pair.
Thanks in advance for your help.
Regards,
Luis
While replacing the grip on my recently acquired 162EI I accidentally popped out two of the three circuit jumpers at the bottom of the circuit board.
How you may ask. I was in the process of reconnecting the board inside the grip and didn't pay attention to the clearance on both sides of the board. It's tight so there was enough deviation for the internal edge of the grip to catch two of the jumpers and pop them out when I pressed the board in. Enough of that!
Can anyone open their metal cover at the botton of the grip and tell me what pins are jumpered together? If you can, please pay attention and make sure you start with the pin closest to the front of the pistol and to list them as:
1 open, 2 open, 3 jumpered with 4, etc.
Keep in mind that there are only 3 jumpers so no reason to go beyond the last jumpered pair.
Thanks in advance for your help.
Regards,
Luis