TargetTalk

Can anyone confirm if a SAM and an MG air pistol cylinders are interchangeable or not. If someone could post or send a picture of their SAM cylinder it would be greatly appreciated.
Thanks
Glenn

I can't post a picture of my SAM cylinder, but here's the best description I can provide:

The valve has a male 'pin' projecting from the end. It is 2mm in diameter and protrudes 1mm.
Then there is an unthreaded diameter of 7.2mm, 2.8mm long.
Then there is a threaded section 9.5mm long. I don't have the tools to identify the thread exactly, but it measures 11.7mm in diameter and appears to be 1mm pitch (I count 9 full threads).

I don't know if anyone in my club has an MG, but if so I will compare next time I have an opportunity.

marky-d

BTW, new SAM cylinders can be found here: https://www.10punkt9.de/
They may be able to tell you if they are the same (although they don't appear to offer MG cylinders).

marky-d

They are not interchangeable. The match gun treaded valve is slightly larger and of a courser tread. The match gun fill adapter slips right over the sam cylinder valve
Aaron. https://postimg.cc/34Ts7k9n

Gentlemen,
Thanks for the prompt replies and information. I was asking because of the 10punkt9 cylinders, now I know they will not work.
Glenn

I ordered a cylinder from these guys back in April for my Sam10 air pistol. It took about 3-4 weeks but no problems. https://tec-hro.de/schiesssport/en/ I just emailed them at this address info@tec-hro.de
they promptly responded sending a pay-pal transfer envoice for payment.
Aaron