Page 1 of 1
pardini front sight
Posted: Fri Jun 19, 2020 10:17 am
by tonyd123
i have a pardini p75 free pistol. The whole front sight assembly is very loose, not the blade but whole thing. Tried green locktite but no luck. any help would be appreciated. thanks. tony donofrio
Re: pardini frony sight
Posted: Fri Jun 19, 2020 11:18 am
by william
Have you gone to the source?
Re: pardini front sight
Posted: Fri Jun 19, 2020 5:12 pm
by Gwhite
There is a set screw under the front sight. I assume you tried tightening that?
If that is stripped, I've seen one with four short set screws drilled & tapped on the sides.
Re: pardini front sight
Posted: Fri Jun 19, 2020 5:44 pm
by Greg Derr
Remove the front sight, then the sight assembly. Paint the area under the assembly that is under the set screw. Allow the set screw to mark the area. Now mill or drill a detent for the sight assembly set screw to nest in. This should solve the problem. The set screw is metric not SAE.
Re: pardini front sight
Posted: Sat Jun 20, 2020 7:46 am
by tonyd123
Thank you all for info.