LG400: how to set the trigger ("let-off point")
Posted: Tue May 28, 2019 6:50 am
Recently I noted that the trigger of my LG400 ('normal', not electronic trigger) had quite a bit of creep.
So out comes the hex key, out comes the user manual...
With the trigger cocked, you're supposed to turn a screw ("e" ) clockwise until the striker is released. And then turn it back by about 0.25 to 0.5 of a turn.
I found that 0.5 turn back is way too much, this clearly gives creep. And even with 0.25 turn some creep is noticeable. So I'm tempted to stay much closer to the 'release point'...
What's your experience? How much do you turn this screw back?
So out comes the hex key, out comes the user manual...
With the trigger cocked, you're supposed to turn a screw ("e" ) clockwise until the striker is released. And then turn it back by about 0.25 to 0.5 of a turn.
I found that 0.5 turn back is way too much, this clearly gives creep. And even with 0.25 turn some creep is noticeable. So I'm tempted to stay much closer to the 'release point'...
What's your experience? How much do you turn this screw back?