TargetTalk

I suspect I might be missing something obvious but I want to adjust the trigger blade position (not the trigger weight etc.) on my KK300 and can't see how.

There's the part that screws up and down on the trigger itself to adjust the contact with the pad on the finger but to either move the blade either backwards/forwards or tilt sideways it appears you need to loosen a hex bolt which sits right on top of the trigger blade itself.

How do you access that?

Thanks!

Would removing the action from the stock work?

there is a set screw inside the hollow trigger stem. Its either 2mm or 2.5mm (cant remember) but be careful, being so small it would be easy to round it off. So put your allen wrench in from the bottom of the trigger stem.

Modena wrote:there is a set screw inside the hollow trigger stem. Its either 2mm or 2.5mm (cant remember) but be careful, being so small it would be easy to round it off. So put your allen wrench in from the bottom of the trigger stem.

Thanks, that sorted it.