Page 1 of 1
Steyr LP50 servicing
Posted: Wed May 16, 2018 11:30 pm
by ForceAwakens
Hi All - I have a Steyr LP50C which I bought about 18 months go. I had recently replaced the grip and noticed some rust on the inside. Do you normally service the pistol yourself or you take it to a servicing center? I am based in Pune, India. Please do advise.
Re: Steyr LP50 servicing
Posted: Thu May 17, 2018 3:55 am
by kevinweiho
Does the pistol have any problems that need to be serviced or you’re just worried about the rust?
Are you storing the pistol in a dry environment along with a silica gel desiccant pack?
Re: Steyr LP50 servicing
Posted: Thu May 17, 2018 4:02 am
by ForceAwakens
kevinweiho wrote:Does the pistol have any problems that need to be serviced or you’re just worried about the rust?
Are you storing the pistol in a dry environment along with a silica gel desiccant pack?
There are no problems with the pistol, I am just worried about the rust and if it will cause bigger issues later. I haven’t used the silica gel packs yet. One of my friends mentioned that sweaty palms (nervousness during shooting) cause moisture that leads to rust - another issue to work on later :-)
Re: Steyr LP50 servicing
Posted: Thu May 17, 2018 7:19 am
by Rover
Some fine steel wool with oil will remove the rust.
Soap will remove corroding bodily fluids from your hands.
Re: Steyr LP50 servicing
Posted: Thu May 17, 2018 8:27 am
by Gwhite
I have fairly corrosive perspiration, and I've had problems with rust under the edges of the grip in the past. I put a line of "RIG" grease just under the edge of my grips to help seal that area. It's not perfect, but it helps a lot.
Storing everything in a dry environment is even better. I grew up in New Mexico, which is mostly desert & very dry. I had zero problems with rust. I moved to Massachusetts, which gets very humid for much of the year, and all my tools and guns started rusting. I had to wipe down my pistols with a silicone cloth every time I touched them, and store them with desiccant packs. Now that I have a house, I have a dehumidifier in the basement and the problem has largely gone away.
Re: Steyr LP50 servicing
Posted: Fri May 18, 2018 1:09 am
by kevinweiho
ForceAwakens wrote:I am just worried about the rust and if it will cause bigger issues later.
If your grip’s anodized finish has corroded, you’ll need to use a rust inhibiting/neutralizing oil or grease.
I use CorrosionX aviation on the metal surfaces of all my guns and I haven’t had any issues. You might also want to consider using a Golden Rod or Eva-Dry renewable dehumidifier.