FAS 609 Regulator question
Posted: Sun Oct 16, 2016 4:13 am
Hi all,
I am new here, I have just re-sealed an FAS 609 (1st series) & the pistol has definitely been "worked on" before.
Currently the gun is experiencing "valve lock" when cylinders with over 110 Bar are fitted. From this I am assuming that the regulator has been tinkered with & the regulation pressure is set too high ?
Can anyone advise or recommend the best washer stack configuration to achieve the best results in this pistol. The gun has 20 washers & 3 shims in the stack.
And also what pressure the reg should be set at ?
Kind Regards,
Matt W :)
I am new here, I have just re-sealed an FAS 609 (1st series) & the pistol has definitely been "worked on" before.
Currently the gun is experiencing "valve lock" when cylinders with over 110 Bar are fitted. From this I am assuming that the regulator has been tinkered with & the regulation pressure is set too high ?
Can anyone advise or recommend the best washer stack configuration to achieve the best results in this pistol. The gun has 20 washers & 3 shims in the stack.
And also what pressure the reg should be set at ?
Kind Regards,
Matt W :)