.32 bullet mold
Moderators: pilkguns, m1963, Isabel1130
.32 bullet mold
Looking for recommendations on 32bullet mold for 32sw-for gsp , thank you
Re: .32 bullet mold
Greetings,
Consider a Saeco #323 in four cavity.
The RCBS 32-098-WC shoots well; but, is only available in 2-cavity.
If you have a stock Walther GSP-C, or GSP-C Expert, odds are the barrel measure 0.3135" +.
Size the as cast bullet to 0.314".
Use a soft lube, like NRA 50-50, Alox-Beeswax.
Cast with a soft Lead alloy, about 8-10 BHN
Lapua brass and 1.65 grains of Winchester WST have worked well for me in the past.
Happy casting, there are not many of us left.
Cheers,
Dave
Consider a Saeco #323 in four cavity.
The RCBS 32-098-WC shoots well; but, is only available in 2-cavity.
If you have a stock Walther GSP-C, or GSP-C Expert, odds are the barrel measure 0.3135" +.
Size the as cast bullet to 0.314".
Use a soft lube, like NRA 50-50, Alox-Beeswax.
Cast with a soft Lead alloy, about 8-10 BHN
Lapua brass and 1.65 grains of Winchester WST have worked well for me in the past.
Happy casting, there are not many of us left.
Cheers,
Dave
-
ghillieman
- Posts: 253
- Joined: Wed Jan 05, 2005 11:07 am
- Location: Mineola, TX
Re: .32 bullet mold
I'm getting good results with the Magma Engineering 93gr button nose flat base wadcutter.
Re: .32 bullet mold
I like exactly what Dave (FC60) recommended. I like alox 50/50 but some seem to come out of the grooves too easily, specifically Lars Alox 50/50. I use the Lars 2500 instead and it seems to work well. Before this I exclusively used 50/50 in other brands and was happy.