Page 1 of 1
Pardini SP barrel question
Posted: Wed Sep 09, 2015 5:07 am
by j-team
Has anyone here ever removed the barrel from the shroud on a late model Pardini SP?
Was just wondering if they are pressed in, glued in, or both?
Re: Pardini SP barrel question
Posted: Wed Sep 09, 2015 10:50 am
by fc60
Greetings,
There are several variations of the the Pardini barrels. The early ones had a "2mm clocking pin" visible at the rear of the shroud and these are press fit assemblies.
The latest Pardini barrels are held in place with "glue". It requires a fixture, heat, and a suitable arbor press to remove one. Not a job for the casual user.
For more exact information, contact PardiniUSA and speak with Emil or Vladimir.
Cheers,
Dave
Re: Pardini SP barrel question
Posted: Mon Jun 25, 2018 3:37 am
by JamesHH
Does anyone have the external dimensions for the 22 SP (glued in) barrel?
I'd like to make my own and the largest OD seems very close if not identical to some standard blanks but its tricky to measure exactly without removing.
Re: Pardini SP barrel question
Posted: Mon Jun 25, 2018 10:33 am
by fc60
Greetings,
There are two variations of the glue model that I know of.
It is best to remove the original barrel and reverse engineer it.
Cheers,
Dave
Re: Pardini SP barrel question
Posted: Thu Aug 02, 2018 3:22 pm
by ChristianFromPardini
Hello j-team,
The barrels on SP models are glued in and the removal is generally a complicated process. I recommend that you have us complete this process to ensure it is done correctly.
Best Regards,
Christian McAfee
Pardini USA LLC
info@pardiniguns.com
Office: 1.813.983.9839
Fax: 1.813.899.1110