Page 1 of 1
izh 46m trigger movement
Posted: Sun Feb 24, 2013 5:29 pm
by charliek
The reach on my 46m is too long and I need to move the trigger back. I have the adjustment screw loose but the trigger won't move and retain it's position. What am I failing to do?
Posted: Sun Feb 24, 2013 5:36 pm
by LukeP
gently insert a screwdriver with flat blade into the slot to enlarge it a little bit, just to move the trigger. when you tight the screw the slot tight himself.
IZH 46m trigger movement
Posted: Sun Feb 24, 2013 7:50 pm
by charliek
The trigger is mounted on a slide. I thought it was pivoted. Many thanks, I anticipated having to whittle on the stock some more.
46M Trigger Position
Posted: Mon Jun 10, 2013 6:03 pm
by Metallurgist
My 46M also has the trigger too far forward. But the factory staked the adjustment screw to prevent it being loosened.
Is this common?
Short of grinding out the portion of the trigger where the threads are staked, has anyone come up with a less drastic way to get that screw loose?
TIA
Bob
Posted: Mon Jun 10, 2013 7:12 pm
by toddinjax
Baikal 46M Trigger Position
Posted: Tue Jun 11, 2013 1:41 pm
by Metallurgist
My 46M also needs the trigger position adjusted. But the factory staked the clamp screw so it can't be loosened (go figure).
Is this common on these?
Has anyone figured out a way to get that screw loose short of just grinding out the the staked portion of the threads? I can do that, but hate taking a dremel to a good gun just on principle.
TIA
Bob