Page 1 of 1
Toz grip screw
Posted: Sun Feb 13, 2011 9:36 pm
by SMBeyer
Anybody know what size the grip screws are for a TOZ 35. I picked up a used one from CDNN and it is missing two. Larry's has them according to their web site but wwas hoping to be able to get them locally if possible(and hopefully for less than $20 a piece). If i cant find any does anybody think tapping the holes just a bit larger for American screws would work?
Scott
Posted: Sun Feb 13, 2011 11:26 pm
by RandomShotz
They are metric: M3. You can get them at a very well stocked hardware store or try McMaster-Carr. I bought a bag of long, cheese head screws (yeah, that's what they are called) in stainless, p/n: 91800A130, and cut them to length as needed.
I'm not sure about tapping the frame - that metal is pretty tough and then you will have the problem of getting the head to fit in the inlet washer that's already there.
Roger
Posted: Mon Feb 14, 2011 5:57 pm
by SMBeyer
Roger,
Thanks, went to Ace Hardware and they had a pretty good assortmant. $.37 seems like a lot better than $20. Scott