Page 1 of 1
CP 2 Help needed
Posted: Mon Nov 29, 2010 12:08 pm
by kopskoot
Replaced all seals on CP2 but now have two spare parts left, a small coil spring .25inch long and .08inch in diameter as well as a matching steel ball, any help as to where they should go please.
CP-2 Leftovers
Posted: Mon Nov 29, 2010 11:06 pm
by ghilt
The spring and the ball detent are used to keep the loading lever open during loading and they go under the L/H rear sight attach screw (ball first then the spring). You are to be congratulated on your dis-assemble technique. The first time I removed the rear sight, the ball fell/rolled onto the shop floor - lost forever! Didn't even bother to look for it. These can be purchased in quantities from ball bearing suppliers. (I now have 99 5/64" Grade 50 balls). Good luck