CP 2 Help needed

A place to discuss non-discipline specific items, such as mental training, ammo needs, and issues regarding ISSF, USAS, and NRA

If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true

Moderators: pilkguns, m1963, David Levene, Spencer, Richard H

Post Reply
kopskoot
Posts: 3
Joined: Mon Nov 29, 2010 11:02 am

CP 2 Help needed

Post by kopskoot »

Replaced all seals on CP2 but now have two spare parts left, a small coil spring .25inch long and .08inch in diameter as well as a matching steel ball, any help as to where they should go please.
Top
ghilt
Posts: 35
Joined: Wed Mar 03, 2004 12:08 pm
Location: SW LA

CP-2 Leftovers

Post by ghilt »

The spring and the ball detent are used to keep the loading lever open during loading and they go under the L/H rear sight attach screw (ball first then the spring). You are to be congratulated on your dis-assemble technique. The first time I removed the rear sight, the ball fell/rolled onto the shop floor - lost forever! Didn't even bother to look for it. These can be purchased in quantities from ball bearing suppliers. (I now have 99 5/64" Grade 50 balls). Good luck
Top
Post Reply

Return to “Shooters Lounge”