Page 1 of 1
Dry shooting on SCATT
Posted: Sun Feb 21, 2010 3:17 am
by tsokasn
So,I purchased a SCATT,and I can say that this thing is going to improve me...
In the fisrt 3 practices I did,I saw a lousy trigger pull...(air riffle)
On my FWB P70,the way to dry fire is to unscrew the air tube and simply arm the riffle and shoot.
How am I going to dry fire my smallbore?
I think that firing the pin in an empty chamber is not the best thing to do.
How will I do it?
Thank you!
Posted: Sun Feb 21, 2010 4:09 am
by Rutty
The answer is Dry Firing Plugs, sometimes referred to as Snap Caps:
The item at the bottom of the page:
http://www.nsra.co.uk/Shop2/Shop_html/Sundries.htm
Rutty
Posted: Mon Feb 22, 2010 4:00 pm
by gerhard
Super
But it seem they dont ship outside UK
I have put a mail to ask for France.
thank for the Links
Posted: Mon Feb 22, 2010 4:06 pm
by Richard H
You can use prefired brass too.
Posted: Mon Feb 22, 2010 8:34 pm
by Guest
How about trying a dry-fire firing pin? Anschutz makes them (if that is what you are using for smallbore). If not, you can always get a new firing pin and use a dremel tool to file it down on the end where it would hit the chamber wall. File it down so that it does not strike when fully extended.
Matthew
Posted: Tue Feb 23, 2010 2:48 am
by tsokasn
Thank you for the advices!
Indeed a bit expensive in UK but I klow what I must search now!
I will also look for the pins.
I will let you know what's cheapest.
Posted: Tue Feb 23, 2010 5:11 am
by gerhard
I dont see what are firing pin ?
Posted: Tue Feb 23, 2010 7:04 am
by David Levene
gerhard wrote:I dont see what are firing pin ?
Striker? The piece that hits the cartridge.
Posted: Tue Feb 23, 2010 7:12 am
by gerhard
Thanks
I see now.
But need to rcha,ge this pice in the bolt.
OK that a good solution.
My english is too poor sometimes to understand all.
Have a nice day.
Gerhard