Page 1 of 1
Gehmann adjustable front sight stuck
Posted: Tue May 27, 2008 12:11 pm
by PaulB
I have a Gehmann adjustable front sight that will not turn and adjust no matter what I have tried. Any suggestions?
Re: Gehmann adjustable front sight stuck
Posted: Tue May 27, 2008 1:58 pm
by RobStubbs
PaulB wrote:I have a Gehmann adjustable front sight that will not turn and adjust no matter what I have tried. Any suggestions?
I have no idea what this thing is like - but will a liberal dowsing with WD40 help free it ?
Rob.
Posted: Tue May 27, 2008 2:04 pm
by pwh
Is it that it will not turn or, that it will turn but there is no adjustment? If its the former you can certainly try the WD-40 or a good silicone oil and let it soak in. I had one but never had any problems with it and I wouldn't care to try and take it apart albeit I'm sure that it can be done.
~Phil
Posted: Tue May 27, 2008 3:31 pm
by peepsight
Some times if the locking clamp ring that tightens the item to the fore sight tunnel is over tight, this may cause the siezure.
Re: Gehmann adjustable front sight stuck
Posted: Tue May 27, 2008 8:49 pm
by Matt
PaulB wrote:I have a Gehmann adjustable front sight that will not turn and adjust no matter what I have tried. Any suggestions?
Find someone who has an ultrasonic cleaner and give the sight a bath in the ultrasonic cleaner. This may dislodge trapped debri in the thread system if there is any present.
If that doesn't prove successful, then try freezing the sight in dry ice for a few hours to shrink the system and then quickly remove it (with gloves) and then briskly attempt to turn the threads. I would not recommend applying any spray lubricant to the sight - it may damage the aperture system.
Good luck.
Matt
Re: Gehmann adjustable front sight stuck
Posted: Wed May 28, 2008 2:35 am
by RobStubbs
Matt wrote:
If that doesn't prove successful, then try freezing the sight in dry ice for a few hours to shrink the system and then quickly remove it (with gloves) and then briskly attempt to turn the threads. I would not recommend applying any spray lubricant to the sight - it may damage the aperture system.
Good luck.
Matt
I suspect if it's stuck, freezing it and shrinking it will make things worse rather than better. The opposite, i.e. heating would probably be better, although you might damage any heat sensitive parts.
Rob.
Posted: Wed May 28, 2008 8:58 am
by pwh
I no longer have the Gehmann site but I believe there are some plastic components to it. I now have an Anshutz adjustable front sight and I know for a fact that it is comprised of some plastic so, heating it could possibly prove to be disastrous!
~Phil
Gehmann front
Posted: Thu May 29, 2008 10:49 pm
by BrianJ
Paulb,
What I've seen happen is that a reaction ocurrs between two moving parts causing the seam to fuse together.
What I did was to hold the supplied spanner wrench in a vise so the sight can engage and rest in it. I then wrapped the knurled end with a narrow width of masking tape about 10 wraps ( enough to not marr the sight when grasping with a channellock pliers. With the spanner engaged grip the taped section and turn. It should break free. Continue to rotate back and forth to lossen.
Brianj