TargetTalk

Posted: **Thu Oct 06, 2005 3:38 pm**

I pump up my cylinder to 200 bars and the hill pump instructions say loosen the bleeder valve than remove your cylinder.When I do this air leaks from the bleeder valve and the cylinder drops in pressure.Now I don't open the bleeder valve and just unscrew my cylinder.Which is correct?Should the bleeder valve let pressure drop from cylinder?Ron

Posted: **Thu Oct 06, 2005 3:55 pm**

Unscrew your cylinder 1/2 - 3/4 turn to close the cylinder valve. Then open the bleed screw.

Steve T

Posted: **Thu Oct 06, 2005 3:59 pm**

SteveT wrote:Unscrew your cylinder 1/2 - 3/4 turn to close the cylinder valve. Then open the bleed screw.

Steve T

TargetTalk

HILL PUMP QUESTION

HILL PUMP QUESTION

thanks Steve