Morini CM 22 RapidFire

If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true

Moderators: pilkguns, m1963, David Levene, Spencer, Richard H

Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
Tycho
Posts: 1049
Joined: Tue Jul 25, 2006 1:25 am
Location: Switzerland

Post by Tycho »

Yes, please give more good news to the 2-owner, so he'll finally go and buy one! (He can try to convince the importer to talk to Francesco about that Torx screw afterwards, no need to muddle that up now...).
Spencer
Posts: 1890
Joined: Fri Feb 24, 2006 9:13 pm
Location: Sydney, Australia
Contact:

Post by Spencer »

Renback wrote:...Do you by any chance have the prefered torquevalue for the main bolt holding the "trigger housing" #022018 ??
Some users report this come loose. Any known problems/solutions regarding this?...
Know this is an oldish thread, but
I am using 3nm, set with an AHG wrench and T20 torx insert
I don't know if the torque settings make any difference to accuracy and will (eventually?) put in some quality time on the ballistics range to find out.

accumulated bits and pieces on the CM22M RF are at http://www.australiancynic.com/MoriniCM22RF.pdf
Post Reply