First, I want to thank you all for your courtesy and helpfulness as I have been struggling along with my new 10m AR focus. Of all of the types of shooting I have done over the years, I find this form, for some reason, to be the most challenging and interesting. I think it is, in part, because of the extreme focus and the almost zen like state of mind required. But enough of that.
I would like your opinions about two issues: 1) the proper forearm grip, and 2) shooting gloves.
First, as to grip, I have tried several styles including the fist, standard between the thumb and index finger, and, my favorite, my "flyfishing grip." With the later, the forearm runs longitudinally from my palm to the end of my middle finger which is straight along the center of the forearm. The remaining four of my fingers grip the forearm two per side. For some reason, I find this grip, for me, to be the most relaxed, stable, and natural. I call it the flyfishing grip because in flyfishing the index or middle finger is extended along the grip of the rod to provide directional stability.
Is this just plain dumb and goofy? What types of grips should I try?
Second, I am at the point of getting a shooting glove (though I have not yet succumbed to the jacket). What do you recommend.
Best Regards,
RFC
Questions re grip and gloves
Moderators: pilkguns, Marcus, m1963, David Levene, Spencer
-
- Posts: 36
- Joined: Sun Jan 21, 2007 6:35 am
Any hand position that supports the rifle at your prefered height, AND keeps the hand steady, will work. Beware of hurting your hand. Shooting off the fist is usually a very stable classic hold, especially if the fingers are parallel with the barrel, but any hand position that doesn't induce bounce or pain will work too.
Re: glove- if you are turning your hand "flat", watch out for the really stiff gloves with heavy plastic or rubber across the back of the hand, like Monard - they will not flex enough. I find that "unusual" hand positions require much testing to get the right fit of glove. (from personal experience because I use a custom hand position due to fist pain). You will also want a glove with as much rubber as possible on the inside of all the fingers. If still available, the red Anschutz 101 (???) might be a good choice, as well as Sauer.
Re: glove- if you are turning your hand "flat", watch out for the really stiff gloves with heavy plastic or rubber across the back of the hand, like Monard - they will not flex enough. I find that "unusual" hand positions require much testing to get the right fit of glove. (from personal experience because I use a custom hand position due to fist pain). You will also want a glove with as much rubber as possible on the inside of all the fingers. If still available, the red Anschutz 101 (???) might be a good choice, as well as Sauer.