MatchGun MG2 Carrier Maintenance

[Gwhite]

I've been promising this one for a while. I originally created it as a 3 video playlist, only I wanted to park it under my overall MG2 playlist. Apparently you can't nest playlists in YouTube without 3rd party software (at least I couldn't find a way to do it).

As result, the 3 videos on maintaining the carrier hardware are lumped in with my other two videos. They are all clearly labeled, but it's not as tidy as I would have liked. In any event, here's the link to the complete MG2 playlist:

https://www.youtube.com/playlist?list=P ... 1BwdNMPPeU

[ghostrip]

Lovely videos. i hope you do an upper frame maintenance video

[Gwhite]

Working on the slide cover is a challenge. I've had to do it three times on my first MG2, which now has over 20,000 rounds through it. My second MG2 has only about 8,000 rounds through it. So far I haven't had to replace anything up top.

I do have a 3D printed bench block design for working on the slide cover. I should try to get that up on Thingiverse...

[deadeyedick]

Great video tutorial Doug. These videos would have made my life much easier back in 2006 when I purchased my first MG2

[Gwhite]

I have my 3D printed MG2 slide cover bench block up on Thingiverse now: https://www.thingiverse.com/thing:6662216

The Summary includes notes on how to use it. It's labeled so you drive the pins in the right direction, and it will accommodate pistols that have one of Jon Eulette's optics rails installed.

Slide Cover Pin Removal.jpg (53.41 KiB) Viewed 178 times