Sam/Anschutz M10 air pistol parts manual

[m1963]

Their response seems terse. Perhaps the language difference.

I also looked at Matchguns...there is nothing similar, there.

[bnice]

Thanks for trying, I’m going to try making a new nylon tip for 362 part. Not out anything but my time at this point.

[m1963]

For reference-

SAM M10 cylinders, fill adaptor, and orings, at

Indoor Swiss
https://shop.indoorswiss.ch/de/suche?co ... arch&s=sam

RB Shooting
https://www.rb-shooting.com/de/#b431/cl ... =and&q=sam

[Rover]

Just FYI...

I emailed Anschutz about Anschutz/SAM 10 repairs. They quickly responded that all repairs on the Anschutz guns were done by SAM thirty years ago.

They had NO suggestions on who might repair them in the U.S.

[ghostrip]

perhaps matchguns mg1 (not mgh1) is a better match. also a good source is user sniper70 in airgunsitaly.it forum as he had repaired/serviced both M10 / Matchguns MG1.

[bnice]

Thanks I look into both and post what I find

[eggen74]

Does anyone have further information about "deadeyedick" and its production of the "quad seal"? because I have the same problem, but I don't see exactly how he makes the "quad seal". Does anyone have a drawing, more informations, or can someone get in touch with "deadeyedick" because he doesn't respond to my PMs.

Regards
Stefan
Switzerland

[Kriss41]

Hello,I have a sam m10 which had pressure problems.I completely dismantled the pressure regulator.
I redid a seal for the cup
You must take an O-ring with an external diameter of 3.2mm.
You cut a 1.5 mm with a cutter and drill in the center to pass the rod through.
You insert it inside the cup.
Once in place it must be slightly recessed in the cup and must not protrude.
Hoping to have helped you.
Regards