Hi,
Is anyone familiar with a mount for the MG5 to fit a SCATT device? I checked on Thingyverse and no returns.
Many thanks
Mark
Match Gun MG5E Scatt mount
Moderators: pilkguns, m1963, David Levene, Spencer, Richard H
Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
Re: Match Gun MG5E Scatt mount
I made some 3D printed blocks for my Morini free pistol a while back. This was for a Noptel trainer, but it should work for a Scatt. I'm not sure if the barrel diameter & taper are the same, but they look close enough.
I've attached a zip file with the two STL files. Due to the taper in the barrel, there is a right & a left side.
I've attached a zip file with the two STL files. Due to the taper in the barrel, there is a right & a left side.
Re: Match Gun MG5E Scatt mount
Superb!
Many thanks
Many thanks
Re: Match Gun MG5E Scatt mount
If the design needs tweaking for the MatchGun, I can export the design as STEP or IGES format CAD files as well.
Re: Match Gun MG5E Scatt mount
I will take a look when I have a spare few minutes. I have been using Cura but have very limited experience. Fusion360 is on my learn to do list.
Re: Match Gun MG5E Scatt mount
What's the barrel diameter on MG5? I'm using the D6-19 clamp on my MU-55
https://www.scatt.com/d6-19-clamp
https://www.scatt.com/d6-19-clamp
First shot always results in good group. The others just don't follow
Re: Match Gun MG5E Scatt mount
am away, will measure on return home.
Re: Match Gun MG5E Scatt mount
its 15.06 mm at a place where you could mount a Scatt unit below. The 3d print will need some rubber slip material to cushion it to fit perfectly. Many thanks G for the files.