Pardini K60 cone seal replacement

[DaHillbilly]

How do you take the K60 apart to replace the bolt (cone) seal?

[prowling]

The loading port pin has to be drifted out, and the loading port separated the bolt. Then remove the barrel set screw from the top of the receiver, and pull the barrel. The bolt assembly will slide right out at that point.

Just did this myself last week ...waiting on the seal kit to arrive.

[6string]

Hi

I need to do this on my K2s.
How does the pin drift out? Seems like the barrel obstructs the pin. Right to Left?

[prowling]

Typical to drift pins from port to starboard, that’s how I removed them on the K60. The K2s may be different though, not sure.

BTW, 6string, are you shooting AP at the Citadel Sectional on the 29th?

[6string]

OK, got this figured out.
One addition to the about instructions. For the K2 and K2s, maybe some others too, the hinge pin for the loading port also has to be removed. The Pardini drawings don't show it, but there is a hole perpendicular to the bore in the rearmost part of the barrel. With the hinge pin out, the barrel slides out easily.