I just purchased a used Walther LP300 AP that included the brass filling adapter part # 2771080. I’ve been to a couple of scuba shops and they can’t come up with the adapter to go from the 7/8” end of the Walther adapter to a SCBA tank or fill hose. Any suggestions?
Thanks and regards, Bill
Walther Lp300 scuba connection?
Moderators: pilkguns, m1963, David Levene, Spencer, Richard H
Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
Re: Walther Lp300 scuba connection?
It was a pain to get my hamerelli hooked up to a hand pump.lol.
The fitting is a 200 bar din I believe. Maybe browse pyramid air you should be able to find necessary fittings to convert it to a yoke.
The fitting is a 200 bar din I believe. Maybe browse pyramid air you should be able to find necessary fittings to convert it to a yoke.
Re: Walther Lp300 scuba connection?
It looks as simple as using an Allen wrench to remove the DGX insert from the tank.
I had to take mine out to put my fill adapter in. My dive dhop has a fill line that screws into the threads after the
insert was removed
I had to take mine out to put my fill adapter in. My dive dhop has a fill line that screws into the threads after the
insert was removed
- dx-70136_1b.jpg (48.03 KiB) Viewed 1132 times
- dx-702282_3b.jpg (29.94 KiB) Viewed 1132 times
-
glenn andrew
- Posts: 14
- Joined: Sat May 02, 2009 7:42 am
- Location: Nova Scotia Canada
Re: Walther Lp300 scuba connection?
This is the adaptor I use. Your local dive shop should be able to order one in and if not you can order this one online.
https://www.ebay.ca/itm/MARES-Din-Yoke- ... 56c339ad3c
Hope that helps
Glenn
https://www.ebay.ca/itm/MARES-Din-Yoke- ... 56c339ad3c
Hope that helps
Glenn