The black plastic ends of the cylinders have grooves. Are these to assist in screwing the cylinder onto the gun or fill tank? This is where the pressure gauge (I use this term loosely) lives.
.45452.0
CM 162 EI Cylinders
Moderators: rexifelis, pilkguns
-
AD
Re: CM 162 EI Cylinders
I suppose it is for a better grip for loosening or tightening the cylinder, I do not think it can serve any other purpose.
AD
akshaydashrath-at-yahoo.co.in.45458.45452
AD
akshaydashrath-at-yahoo.co.in.45458.45452
-
mako
do not over tighten! ... finger tight on the barrel is enoug
: I suppose it is for a better grip for loosening or tightening the cylinder, I do not think it can serve any other purpose.
: AD
makofoto-at-earthlink.net.45485.45458
: AD
makofoto-at-earthlink.net.45485.45458
-
Michael
Re: do not over tighten! ... finger tight on the barrel is e
I thought that it might be for disassembly of the air pressure guage for repair. Heaven knows it needs it!
: : I suppose it is for a better grip for loosening or tightening the cylinder, I do not think it can serve any other purpose.
: : AD
.45540.45485
: : I suppose it is for a better grip for loosening or tightening the cylinder, I do not think it can serve any other purpose.
: : AD
.45540.45485