Toz Front sight blade

[Brian]

Has anyone managed to find or for that matter heard of a taller front sight blade being available for the toz 35?
thanks
Brian
.44587.0

[BMS]

In our shop we have had to either add a bead of weld or silver solder shim stock on top of the sight. Typically about .45" - .050" to get the TOZ to shoot "center hold".
We have also cut the rear sight plate in the mill to do the same thing. The rear is often not square so, this can accomplish 2 things at once.
: Has anyone managed to find or for that matter heard of a taller front sight blade being available for the toz 35?
: thanks
: Brian


denniss-at-burntmill.com.44608.44587

[Jim]

I don't know if this is what you need but I have a set of sight blades. 2 front blades one is .360" the other is .370" (blade face height). 4 rear blades, each with U notch and square notch. Widths vary from 2.8mm to 3.5mm. Also 2 springs for the rear sight. I would like to let these go as a set. Anyone know what they're worth?
Jim


james.buckland-at-converse.edu.44614.44608

[pelletHed]

: In our shop we have had to either add a bead of weld or silver solder shim stock on top of the sight. Typically about .45" - .050" to get the TOZ to shoot "center hold".
: We have also cut the rear sight plate in the mill to do the same thing. The rear is often not square so, this can accomplish 2 things at once.
: : Has anyone managed to find or for that matter heard of a taller front sight blade being available for the toz 35?
: : thanks
: : Brian


.44651.44608