Anschutz 7020 Thread Size

bpscCheney · Post by **bpscCheney** » Thu Mar 28, 2013 6:08 pm

Hey, I was wondering if any of you guys out there happened to know the thread size for the two screws that attach the 7020 sight to the sight rail. I just so happen to have sheared mine whilst tightening it. :/ Near as I can tell it is in between a M3 and an M4 thread size. Any help would be appreciated.

jhmartin · Post by **jhmartin** » Thu Mar 28, 2013 9:49 pm

You got it!
M3.5

bpscCheney · Post by **bpscCheney** » Thu Apr 04, 2013 5:01 pm

OK well I finally heard back from Anschütz and they said, "the size for the spindle is :Spindel Rd6.35x30.3"

Is that in fact a M3.5?

jhmartin · Post by **jhmartin** » Thu Apr 04, 2013 8:11 pm

Yes, M3.5 with length of 30.3mm
So if you can find 35-40mm long screws you're in shape ... you can always trim them down with a Dremel and a cutoff disc.
(Trim after you get them installed)

bpscCheney · Post by **bpscCheney** » Thu Apr 04, 2013 9:15 pm

OK thanks for the help! This is why I frequent here.