izh 46m trigger movement

charliek · Post by **charliek** » Sun Feb 24, 2013 5:29 pm

The reach on my 46m is too long and I need to move the trigger back. I have the adjustment screw loose but the trigger won't move and retain it's position. What am I failing to do?

LukeP · Post by **LukeP** » Sun Feb 24, 2013 5:36 pm

gently insert a screwdriver with flat blade into the slot to enlarge it a little bit, just to move the trigger. when you tight the screw the slot tight himself.

charliek · Post by **charliek** » Sun Feb 24, 2013 7:50 pm

The trigger is mounted on a slide. I thought it was pivoted. Many thanks, I anticipated having to whittle on the stock some more.

Metallurgist · Post by **Metallurgist** » Mon Jun 10, 2013 6:03 pm

My 46M also has the trigger too far forward. But the factory staked the adjustment screw to prevent it being loosened.

Is this common?

Short of grinding out the portion of the trigger where the threads are staked, has anyone come up with a less drastic way to get that screw loose?

TIA

Bob

toddinjax · Post by **toddinjax** » Mon Jun 10, 2013 7:12 pm

I once again suggest this replacement:
http://www.pyramydair.com/s/a/Air_Ventu ... embly/4101

Metallurgist · Post by **Metallurgist** » Tue Jun 11, 2013 1:41 pm

My 46M also needs the trigger position adjusted. But the factory staked the clamp screw so it can't be loosened (go figure).

Is this common on these?

Has anyone figured out a way to get that screw loose short of just grinding out the the staked portion of the threads? I can do that, but hate taking a dremel to a good gun just on principle.

TIA

Bob

TargetTalk

izh 46m trigger movement

izh 46m trigger movement

IZH 46m trigger movement

46M Trigger Position

Baikal 46M Trigger Position