CM162EI - short removing the rear sight extension

A74BEDLM · Post by **A74BEDLM** » Sat Jan 21, 2012 5:05 am

The CM162EI is listed as having the same sight radius as the long. Is it possible to remove the rear sight extension and fit a long grip (cut out on the short and the long is in different place due to rear sight extension)?

This would in theory give you a much shorter sight radius.

I appreciate that this is not to everyone's taste due obvious arguments vs reduced barrel lengths and Short sight radius vs Long I'm just curious.

ghostrip · Post by **ghostrip** » Sat Jan 21, 2012 3:14 pm

i believe it is possible. i have seen a long 162 with the extension and the grip from the short to get the maximum sight length. so a short 162 with the the extension removed is doable.

Tycho · Post by **Tycho** » Sun Jan 22, 2012 4:27 am

Yep, no problem.

A74BEDLM · Post by **A74BEDLM** » Tue Jan 24, 2012 3:30 am

I created one last night with a friend's donor CM162 short and my CM162 long. Swapped Barrel and cylinders - kept the original long sight and grip. Was able to create a Short with a sight radius of 260-305mm. (I'm using the blow-back compensator from Interprodukter.se so different to standard compensator sight positions).

It's so much more stable and better balanced (for me) then the long and this was reflected in the grouping exercise last night at the range.