Anschutz 1907 500mm alignment pin???

oddsonjjf · Post by **oddsonjjf** » Thu Oct 27, 2011 9:41 am

Ok,
Have a young shooter that has an Ans 1907 with 500mm barrel. The barrel has a bloop tube either made by Anschutz or cc. (not sure) the tube or extension is slid on and seats flush against the barrel. The barrel has an alignment post that sticks out of the barrel. Should I say had. Hence, my predicament. I have been charged with the task of trying to find a replacement post/aligner/pin. Any ideas????

Barney · Post by **Barney** » Thu Oct 27, 2011 10:02 am

Get a roll pin that fits the hole and put a drop of loctite in before tapping it in. It ony needs to stick out about 1/4 of an inch if is a factory anschutz tube

justadude · Post by **justadude** » Thu Oct 27, 2011 10:12 am

I have never worked with the Anschutz 500mm barrel/tube setup. Could you provide a picture of the broken pin?

'Dude