Crossman 167 Pellgun

kopskoot · Post by **kopskoot** » Fri Dec 31, 2010 6:43 am

Hi All

I have taken a very old Crossman C02 out of hibernation, but seals are leaking. Managed to strip all down to basics, except that I am left with the lower tube and what I think should be the valve assembly. I can get no further as there is a large pin that holds rest together with a spring loaded pin in place preventing me from removing the rest. Any advice on how to proceed further please.

Kopskoot

Post by **pilkguns** » Fri Dec 31, 2010 6:57 pm

you should ask this on yellowforum.com

They would be more likely to know what to do about this and who to send to.

Tony C. · Post by **Tony C.** » Fri Dec 31, 2010 11:21 pm

Another site you can try is the Vintage American Airgun Forum, in many ways its much better than the Yellow Forum, give it a try, here is the link:

http://www.network54.com/Forum/405945/

kopskoot · Post by **kopskoot** » Sat Jan 01, 2011 4:22 am

Thanks Pilkguns & Tony C, I managed to sort the problem out myself, the pin is threaded and simply unscrews, now I have access to the valve and seals. I do need some more advice though and will follow your suggestions in as far as other sites are concerned.

Regards

kopskoot