Hello,
I'm considering purchase of a Morini 162 EI but would like a weight system similar to an Anshutz LP. I'm sure there is a way to rig something like this? Any ideas?
Thanks
DAF
Morini 162 Weight System
Moderators: pilkguns, m1963, David Levene, Spencer, Richard H
Forum rules
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
If you wish to make a donation to this forum's operation , it would be greatly appreciated.
https://www.paypal.com/paypalme/targettalk?yours=true
It's been mentioned here a few times. Best system for the Morini is to cut the end off a 35mm film canister and attach some self-stick tyre weights to these. I use the 5g weights as you do not have to bend them to conform to the plastic tube.
Slide the tube over the air cannister. It is a perfect fit and doesn't scratch the cannister. Depending on your preference you can have the weight as far forward as under the front sight or closer back to the trigger guard.
In matches where the shakes take over and the front sight seems to be dancing to a tune of its own, I push the weight right forward and it reduces the shakes a little.
Slide the tube over the air cannister. It is a perfect fit and doesn't scratch the cannister. Depending on your preference you can have the weight as far forward as under the front sight or closer back to the trigger guard.
In matches where the shakes take over and the front sight seems to be dancing to a tune of its own, I push the weight right forward and it reduces the shakes a little.