Rear sight sigh standard military model

keeper · Post by **keeper** » Wed Jan 14, 2009 11:26 am

Can someone give me the procedure for remove the rear sight from my 106 military model high standard.

jackh · Post by **jackh** » Wed Jan 14, 2009 1:41 pm

Do you mean the bridge sight from the frame?

If so, remove the sear and sear spring, drive the pin at the rear forward into the frame. Remove one of the large sex pins through the small hole in it's opposite side. Then remove the second half. Use well fit drift punches. Then drive the small roll pins on the side inward ONLY enough to clear the bridge legs.

keeper · Post by **keeper** » Thu Jan 15, 2009 4:56 am

Thank you sir. I removed it with no problem.