TargetTalk

I'd suspect some sort of error in the trigger-finger placement. Check these documents and perhaps adjust trigger position accordingly. I suppose I should have said that it is not happening with every shot, but enough that there seems to be a pattern with this particular pistol. I should also have s...

In shooting my recently acquired (used but recently serviced by Pilk) LP 50, I have noted a distinct tendency to pull ever so slightly to the left, which is not present when bench sighting. We're talking less than a centimeter, but enough to pull a ten to a 9 or 8. I suspect that it is caused by the...

My elbow still hurts, though. Takes a while to heal.

Right, no change in the scores.
I can do as well with my IZH as I can with my Morini.

Actually, Rover is right. A box of rags works just fine as a pellet trap. I took Rover's advice recently and got a used K58, which is a great gun. My only problem was one of enthusiasm. The repeated pumping caused tendinitis in my elbow, so I wound up buying a PCP. But, he gives good advice to those...

Rather than using rags for a backstop, you can use electrical "Duct Seal", available from Home Depot or Lowe's. It's quiet, and a quarter or half inch is all thats needed to absorb a pellet. After a few hundred rounds, just replace it. John I second this suggestion. Use of duct seal is co...

Thanks for the correction! Not the barrel.

Gerard, Just wanted to say thanks, from all of us Izzy owners who may have modified our grips (I'm currently working on my second set with an increased rake angle) and knew the pistol was too heavy, but had no idea where to begin shaving off the excess weight. Your picture and description were great...

My 46M had a small shim on one side, obviously put in by the factory to take up some of the slack made by poor fitting grips. The tape, a matchstick (without the head), or similar shim will work fine.
--Pete