Lost the same parts out of my 90s 32. Went back to the range a few days later with a magnet and found them all.
Good luck magnet fishing.
Search found 6 matches
- Thu Aug 10, 2023 8:30 pm
- Forum: Bullseye Pistol Talk
- Topic: Benelli MP90S World Cup????? parts
- Replies: 8
- Views: 18672
- Thu Oct 14, 2021 11:51 am
- Forum: Olympic Pistol
- Topic: Unfastening the very tightly screwed PCP Cylinder
- Replies: 40
- Views: 9997
Re: Unfastening the very tightly screwed PCP Cylinder
I use a nonskid place mat for a pistol mat/rug. It does a great job of protecting the gun from bench ware and when the cylinder is tight it give you a good grip. When going to Camp Perry back in 2000 I was looking for an all weather pistol mat, I run across these at Camping World. I have them with a...
- Mon Sep 06, 2021 7:50 pm
- Forum: Bullseye Pistol Talk
- Topic: Bullseye Pistol?
- Replies: 6
- Views: 3527
- Mon Jul 05, 2021 1:37 pm
- Forum: Olympic Pistol
- Topic: 10m rapid fire pistol target size?
- Replies: 1
- Views: 513
10m rapid fire pistol target size?
Our club has set up 10m turning targets for rapid fire air pistol. ISSF rules for 5 short air pistol is 30 cm center to center and a 30mm scoring hole. This part of the match is a hit or miss score. RF rules may be different I have been looking for the the rules for conversion of the 25m target for ...
- Sat Dec 07, 2019 1:17 pm
- Forum: Olympic Pistol
- Topic: LP5 Cycle Problems
- Replies: 8
- Views: 1821
Re: LP5 Cycle Problems
Check the barrel adjustment, if the barrel is protruding into the magazine space it will hang up the advisement of the magazine. Adjust with the two barrel adjustment screws. The breach should be flush with the front face of the magazine space.
Rob
Seattle, WA
Rob
Seattle, WA
- Thu Nov 21, 2019 12:18 pm
- Forum: Olympic Pistol
- Topic: Benelli extractor popping off
- Replies: 5
- Views: 2112
Re: Benelli extractor popping off
Had the same problem on my 90s. On a trip to Maine in 2016 I stoped by Larry's shop in Gray ME. I showed him the bolt he took apart the extractor. measured the depth of the spring hole, told me the factory drilled it to deep, dropped a ball bering in the hole to make up the deference. He said it's n...