TargetTalk

That one?

It sounds like the loading lever has been shimmed wrong or they have pinched the shim washers. Make sure the shims are not caught under the shoulder. Well, I decided to carefully try opening the loading lever screw. Turns out it was relatively tight, but not at all super tight. It came out all the ...

Thank you, David!

It is certainly a possibility, that when they tightened the screw, the screw started to force the bottom shim down into the threaded hole in the frame. Does this pic give any further clues?

Ok, I let someone who was recommended to me work on the gun. The results were not great. They replaced a bunch of parts (see the pics below) and the leak appears to be gone, BUT ... 1. The loading lever is now angled wrong (I noticed this immediately while unboxing the pistol). 2. All parts of the l...

I remember the trigger on mine randomly somehow getting stuck so that when retrying an aborted shot, there would be no pre-travel at all. That could be dangerous, even. Any ideas as to what might've been wrong with the pistol?

This was my experience with Prelutec: [LINK - PDF1] [LINK - PDF2] - Main problems in 2020: The grey cylinder was 1 year older than expected and did not even work (pistol wouldn't fire). - Main problems in 2022: The blue cylinder was 2 years older than expected. Lots of cosmetic(?) defects, kind of m...

I don't agree with Gwhite on the first point being unlikely. The gun to cylinder seal would be my first check. From my experience it's the first seal to go due to the screw/unscrew of the cylinder. On the Morini, that seal is actually in the cylinder, if I've understood correctly? I'd say it "...

Thanks! I once again filled the cylinder to 160 bar and then left it alone for some 20 hours. No air had leaked, as far as I could tell. Then I installed the cylinder on the pistol. Now I could clearly hear a hissing sound, seemingly coming from where the cylinder attaches to the gun. I waited for a...

Hi, I'm the owner of a Morini CM162EI (also known as CM162EA) manufactured in approximately 1998/1999. It's the old model with the 15 Volt photo battery. I have two cylinders that very well may be just as old as the gun itself. One of them is leaking from the manometer end and the other from the end...