TargetTalk

Seems like a lot of ideas on 32 wad but I have used the standard 4 die set from RCBS for years with no problems. Size cases I/8 short of pressure ring Size only enough to expand case mouth to receive lead bullet, Seat with the seating die to barley flush Taper crimp to hold bullet Used the Walther i...

After many years with the Walther 32 I found that the best at 25m was Lapua with hollow base bullet. Luckly I had a Team member who cast bullets as a hobby and he made a mold with hollow base matching the Lapua factory load in 314Dia. Again, Lapua brass is soft and care should be sure the front of t...

Gunrunner & Jon Eulette:
Thank you both for the information on the trigger stop.
Have 4 ,1911 in NM style but only one with this set up.

As a Rifle shooter, am aware of the over travel thing

Larry

What value is the adjusting screw other than override, and what is the correct adjustment?

Thanks
Larry

Been a while but during the Natl's, Had a major reloading problem with new brass. Finally found that just small smoothing and chamfer of the front of the barrel at the ramp and no more failure to feed. Seems that the sharp finish cut into the brass during feed
Hope this helps

Larry